Reducer rings for cutter heads
Cutter heads are produced with different bore sizes, while the spindle of your milling machine (toupie) has one fixed diameter. A reducer ring for cutter heads, in this range designed as an adaptor for the bore, bridges that difference and keeps the cutter head exactly centred on the spindle.
With cutter heads, correct centring is especially important. The mass of the head turns even a small deviation into noticeable vibration and a wavy milling pattern. Choose the adaptor therefore exactly according to the combination of the cutter head bore and the spindle diameter of your machine. Fit the ring clean and grease-free. Unsure between two sizes? Then measure the bore carefully with a caliper rather than relying solely on the nameplate.
Filters
Availability
D (diameter) in mm
d (small diameter) in mm

Transition piece for bore hole D=19,5mm d=12,7mm
- D=19,5 x 12,7

Transition piece for bore hole D=25,4mm d=19,05mm
- D=25,4 x 19,05

Transition piece for bore hole D=30mm d=19,05mm
- D=30 x 19,05

Transition piece for bore hole D=30mm d=25,4mm
- D=30 x 25,4

Transition piece for bore hole D=31,75mm d=19,05mm
- D=31,75 x 19,05

Transition piece for bore hole D=31,75mm d=25,4mm
- D=31,75 x 25,4

Transition piece for bore hole D=31,75mm d=30mm
- D=31,75 x 30


Transition piece for bore hole D=35mm d=31,75mm
- D=35 x 31,75







