Drill holders for dowel drills
In a dowel drilling machine or drilling unit, a dowel drill is not mounted directly in the spindle: the connection is made via a drill holder for dowel drills. This category includes drill holders in left- and right-hand versions, available as a flat base version, with a centering seat of 11 × 4 mm or with a centering cone in various angles, including 20°48' and 30°.
The direction of rotation is the most important selection criterion. Drilling groups drive their spindles alternately counterclockwise and clockwise, which means both versions are needed as a pair. Then choose the correct mount for your dowel drills — a seat or cone — and check this combination carefully. A drill that does not fit fully into the correct seat will run out of true. In dowel joints, even a small deviation immediately leads to joints that do not fit properly.
Filters
B (bore) in mm
L (total length) in mm
S (shank) special
S1 (shank diameter 1)
Markings (connection)
d (small diameter) in mm
D (diameter) in mm
Rotation direction

Quick-change drill chuck for Vitap, right and left D=18mm B=10mm
- D=18mm d=17,5mm
- LT=42mm
- Right- and left-hand rotation

Quick-change drill holder for Morbidelli, right and left D=20mm B=10mm
- D=20mm d=19,5mm
- LT=43mm
- Right- and left-hand rotation

Quick-change drill holder for Masterwood, right and left D=20mm B=10mm
- D=20mm d=19,5mm
- LT=40mm
- Right- and left-hand rotation

Quick-change drill holder for Weeke, right and left D=17mm B=10mm
- D=17mm d=2mm
- LT=46mm
- Right- and left-hand rotating
4 of 28 products shown