S-Lock – Quick-Change System
The S-Lock quick-change system from GRN is built around a quick-change holder with easy plug removal: after drilling, you simply push the wooden plug out of the hole saw, without prying with a screwdriver. For anyone drilling holes in series — spots, pipe penetrations, cable routes — that means daily time savings.
In this category, besides the quick-change holders, you will also find the matching HSS pilot drills, a 300 mm extension for deeper or harder-to-reach drilling, an adapter from SDS to hexagon, and adapter sets that fit all types of hole saws from 32 mm onto the holder.
Thanks to the adapters, you do not need to replace existing hole saws when switching to S-Lock — you simply equip them with the new connection.
Filters
Cutting material
L1 (length 1) in mm
Type
L (total length) in mm
S (shank) special
Rotation direction
Material to be machined
Packaging unit

Extension 300mm S=Shank with 3 flats M10 B=10mm
- L=300mm

Adapters (3x) for all types of hole saws < 32mm
- Connection for diameter < 32mm
- For GRN quick-change holders

Adapters (3x) for all types of hole saws >= 32mm
- Connection for diameter > 32mm
- Perfect match with 550-PHG1

Set of 3 adapters for enlarging holes
- 3 pieces
- for all GRN hole saws
- Suitable for Ø16-270mm

HSS drill bit suitable for GRN quick-change holder(s) · 550-PDG06
- For wood and metal
- Ease of use

HW drill suitable for GRN quick-change holder(s)
- For soft stone, tiles, ...
- Ease of use

Quick-change arbor for hole saws + HSS drill S=Hexagonal
- For GRN hole saw arbors
- Quick hole saw changes possible
- Hex shank

Dust cap for hole saws
- For use with 550-PHG1
- Up to diameter 152mm

Transition adapter from SDS to hexagonal S=SDS L=85mm
- Suitable for 550-PHG1
- Fast drill changes possible
- Optimal power transfer
S-Lock by GRN: quick-change arbors and adapters for hole saws
S-Lock is the quick-change system from GRN Tools. It works with a quick-change arbor in the drill and an adapter on the hole saw, which also makes hole saws with a screw connection quickly interchangeable. Here you will find quick-change arbors with HSS pilot drill bits, including a version with easy plug removal, adapters sold in sets of three in two size ranges, separate HSS and HW pilot drill bits, an SDS-to-hex shank adapter, a 300 mm extension, an adapter set for enlarging holes and a dust cap.
Adapters below and from 32 mm
The adapters are supplied in sets of three, in one version for hole saws smaller than 32 mm and one version for hole saws from 32 mm. That limit coincides with the screw connection: in the GRN ranges carbide hole saws 550G and bi-metal hole saws 551G, diameters up to 30 mm have a 1/2" connection and sizes from 32 mm have a 5/8" connection. So count in advance how many hole saws you use in each range, so that each saw gets its own adapter.
Plug removal, extension and dust cap
With the quick-change arbor with easy plug removal, you can quickly remove the cut-out plug from the hole saw after drilling, without prying with a screwdriver — a noticeable time saving when drilling holes in series. The 300 mm extension brings the hole saw to hard-to-reach places. With the SDS-to-hex shank adapter, the arbor fits in a rotary hammer; in that case, use it exclusively in drilling mode. The dust cap captures part of the drilling dust.