Cylinder Head Drills – Cylindrical Shank
For the drill chuck of a standard drill or a CNC unit, the cylinder head drill with cylindrical shank is the standard solution: you clamp the smooth shank into a drill holder or collet chuck. The range includes well over one hundred references in diameters from 8 to 80 mm, right-hand cutting, with a choice of a standard or long cylindrical shank.
The long-shank version provides extra reach when the drill head cannot bore deep enough. In addition, there are versions without scoring cutters: choose these when the edge quality of the hole is less critical and you mainly want to drill through quickly. For visible work in veneer or melamine, the version with scoring cutters remains the safest choice.
When you are looking for cylinder head drills for your CNC machine, it is best to look at cylinder head drills with a shank with flat.
What diameter should the borehole be?
Filters
D (diameter) in mm
Cutting material
Brand
L1 (length 1) in mm
S (shank) in mm
L (total length) in mm
Line

Cylinder head drill D=35 with long cylindrical shank, right S=16mm
- D=35mm
- LT=130mm
- S=16x50mm Z2+V2

Cylinder head drill D=40 with long cylindrical shank, right S=16mm
- D=40mm
- LT=130mm
- S=16x50mm Z2+V2

Cylinder head drill D=45 with long cylindrical shank, right-hand S=16mm
- D=45mm
- LT=130mm
- S=16x50mm Z2+V2

Cylinder head drill D=50 with long cylindrical shank, right S=16mm
- D=50mm
- LT=130mm
- S=16x50mm Z2+V2

Cylindrical head drill D=55 with long cylindrical shank, right-hand S=16mm
- D=55mm
- LT=140mm
- S=16x50mm Z2+V2

End mill cutter D=60 with long cylindrical shank, right-hand S=16mm
- D=60mm
- LT=140mm
- S=16x50mm Z2+V2
HW countersink HWM right
- D=12mm
- I=8mm LT=60mm
- S=10 Z=2+2
7 of 103 products shown
Hinge drills (cylindrical head drills) with cylindrical shank
A cylindrical head drill, often called a hinge drill or pot drill in the workshop, drills a hole with a flat bottom and a clean edge: exactly what a cup hinge, a flush-mounted magnet or an insert requires. These versions have a smooth cylindrical shank of 8, 10, 13 or 16 mm, which you clamp in the chuck of a drill or pillar drill or in a collet chuck. They rotate clockwise and are also available with a long shank for extra reach.
35 mm hinge drill and other diameters
The 35 mm is the classic cup diameter of concealed hinges and therefore the most requested size. However, the range runs from 8 to 80 mm: smaller diameters are used for magnetic catches and inserts, larger ones for recessed spotlights, cable outlets and round inlays. Most drills have carbide cutting edges and two scoring cutters that pre-cut the fibre and the top layer; a version without scoring cutters drills through faster where the edge matters less. For drilling machines and CNC, choose the cylindrical head drills with flat shank.
Drilling with a depth stop
For hinge holes, only a few millimeters of material remain under the bottom. Therefore always work with a depth stop and test on scrap wood of the same thickness. Drill square—an angled hole puts the hinge under tension and makes the door hang—and at a moderate speed: the larger the diameter, the lower the speed. Clamp the workpiece securely, because a cylindrical head drill develops a lot of torque, and withdraw the drill regularly so the chips can clear.