CNC tool holder parts
CNC tool holders are only as accurate as their wearing parts. In this category you will find parts for CNC tool holders: clamping nuts for ER40 and DIN 6388 collets, bearing-mounted clamping nuts for low-vibration clamping, clamping nuts per holder, and flanges with a raised edge of Ø40 mm.
A clamping nut is a typical wear part. It is tightened with every tool change and, over time, the thread or contact face can lose precision. The result is a milling cutter that no longer runs perfectly true. Replace the clamping nut if there is visible wear or unexplained runout errors. When ordering, pay attention to the collet type and the rotation direction of your holder. A bearing-mounted clamping nut can be tightened correctly to torque with less force.
Filters
Availability
B (bore) special
B (bore) in mm
D (diameter) in mm
Collet system
Rotation direction


Collet nut for ER20 collet, left-hand D=35mm
- D=35mm x M25x1,5
- LH (left-hand)
- Without bearing ring
2 of 26 products shown