Fish-tail drills – threaded shank
Some mortising machines do not accept their tooling via a chuck, but via a threaded mount. For that purpose there is the fish-tail drill with threaded shank. The drill is screwed directly onto the drive, creating a secure connection that cannot slip under sideways cutting loads. The range includes not only a classic right-hand fish-tail drill, but also mortising cutters with diameters from 10 to 16 mm.
Choose the diameter according to the width of the mortises you make most often. With a 16 mm cutter, you can machine wide mortises faster, while 10 or 12 mm leaves more reserve to stay exactly on the marking. Screw the drill onto the thread hand-tight and carefully: the cutting direction pulls the drill tighter on its own during operation.
What diameter should the borehole be?
Filters
Availability
D (diameter) in mm
Cutting material
Brand
L (total length) in mm
Material to be machined

Lock housing cutter D=10, right L=100mm
- D=10mm
- LT=100mm
- S=M12x1 Z2

Lock housing cutter D=12, right-hand L=100mm
- D=12mm
- LT=100mm
- S=M12x1 Z2

Lock mortising cutter D=14, right-hand D=14mm S=M12x1
- LT=100mm
- S=M12x1 Z2
- RH (right-hand rotation) HW

Lock case cutter D=16, right-hand D=16mm S=M12x1
- LT=100mm
- S=M12x1 Z2
- RH (right-hand rotation) HW

Fish-tail drill bit, right D=18mm L=105mm · 163.180.11
- LT=105mm
- S=M12x1 Z2
- RH (right-hand rotation) HW

Fish-tail drill bit, right D=18mm L=105mm · 163.180.31
- LT=105mm
- S=M12x1 Z2
- RH (right-hand rotation) SP
Bore bits and mortise box cutters with threaded shank
Some mortising machines do not hold the tool in a drill chuck, but by means of a thread. These bore bits and mortise box cutters with M12x1 threaded shank are intended for that purpose. You screw them directly onto the drive, which gives a solid connection that cannot slip when the cutter is subjected to lateral load. They rotate to the right, usually with carbide cutting edges, in diameters from 10 to 18 mm.
Diameter according to the mortise box
Choose the diameter according to the width of the mortises you make most often. With a 16 or 18 mm cutter, you can machine wide mortises faster; with 10 or 12 mm, you keep more reserve to stay exactly on the marking. Cut in depth passes of a few millimetres and let the cutter remove only a limited width per pass, so that the chip is carried away smoothly and the cutter does not start to vibrate.
Thread and mounting
Before ordering, check whether the drive of your machine has an M12x1 thread. Tighten the cutter by hand onto a clean thread: sawdust or chips in the thread prevent it from seating fully, and then it will not run true. Because all cutters rotate to the right, the cutting direction pulls the cutter tighter during operation; so never use force when tightening.