CNC saw blade holder
For cutting grooves, separating panels or making angled cuts directly on the CNC machine, fit a saw blade in a CNC saw blade holder. These precision holders are available with an HSK-F63 shank for modern machining centres and with a cylindrical shank for spindles with collet chuck mounting, and clamp the blade exactly square and concentric on the spindle.
A saw blade on a CNC spindle places higher demands than a cutter: the large diameter amplifies any imbalance. Therefore, at every blade change, check the contact surfaces of flange and blade for chips and resin residue, and tighten the fixing according to the instructions. This keeps the cut clean and prevents vibrations that affect both the cut quality and the spindle bearings. With the right holder, your CNC becomes a fully-fledged sawing station.
Filters
Connection type
L (total length) in mm
D (diameter) in mm

Precision saw holder with cylindrical shank D=59mm S=20mm
- Collet system:
- Connection type: 20 mm
- Direction of rotation: Right and left

Precision saw holder with HSK-F63 shank D=59mm L=78mm
- Clamping system:
- Connection type: HSK-F63
- Rotation direction: Right and left

Precision saw holder with HSK-F63 shank D=98mm L=102mm
- Clamping system:
- Connection type: HSK-F63
- Rotation direction: Right and left

Precision saw holder with HSK-F63 shank D=110mm L=40mm
- Clamping system:
- Connection type: HSK-F63
- Rotation direction: Right and left
CNC saw blade holders with HSK-F63 or cylindrical shank
With a saw blade holder, you use a circular saw blade on your CNC machining centre instead of a milling cutter, for example to saw grooves, separate panels or make straight cuts. Here you will find precision saw blade holders from CMT with HSK-F63 shank for saw blades up to Ø 250, 300 or 350 mm, and a version with a 20 mm cylindrical shank for collet chucks. All holders accept saw blades with a 30 mm arbor hole and are suitable for right- and left-hand rotation.
Sawing instead of milling on the CNC
For straight through cuts in sheet material, a saw blade is often more efficient than a milling cutter: it cuts a narrow kerf with low chip volume and a high feed rate. The holder determines the maximum blade diameter and therefore the cutting depth: choose the 59, 98 or 110 mm flange depending on whether you want to use blades up to Ø 250, 300 or 350 mm. Check that limit against the thickest board you process, and take into account the space around the spindle of your machine.
Arbor hole, flanges and speed
The saw blade must fit the holder exactly with its 30 mm arbor hole; also check whether the drive holes of the blade match those of the holder (4/M6/48 or 6/M6/80). In addition, make sure that the blade's maximum speed is higher than the spindle speed — at CNC speeds, that is no mere formality. Keep the flanges completely clean: one chip between flange and blade causes runout and thus a wavy cut edge.